Comnet CNGE2FE8MSPOE Technical Information PDF herunterladen (Seite 26)

3.5 Wiring the Fault Alarm Contact

The fault alarm contacts are in the middle of the terminal block connector as the picture

shows below. Inserting the wires, the switch will detect the fault status of the power failure,

or port link failure (available for managed model) and then forms an open circuit. The

following illustration shows an application example for wiring the fault alarm contacts.

[NOTE]

The wire gauge for the terminal block should be in the range between 12 ~ 24

AWG.

Insert the wires into the fault alarm contacts

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 161 162

Keine Kommentare

Comnet CNGE2FE8MSPOE Technical Information Seite 26