Comnet CWGE2FE8MSPOE Technical Information PDF herunterladen (Seite 86)

be aggregated in a trunk group. Click and the ports focused in the right

side will be shifted to the left side. To remove unwanted ports, select the ports and

click .

 When LACP enabled, you can configure LACP Active/Passive status for each port on

the State Activity tab.

 Click .

 Use

to delete Trunk Group. Select the Group ID and click .

Port Trunk—Aggregator Setting interface (four ports are added to the left field with LACP enabled)

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 142 143

CWGE2FE8MSPOE 1
FCC Warning 2
CE Mark Warning 2
Content 3
Introduction 8
Features 9
Hardware Feature 11
Software Feature 14
Package Contents 17
Hardware Description 18
available with a 19
Rear Panel 20
Desktop Installation 21
Power On 21
Network Application 22
Segment Bridge 23
Console Management 24
CLI Management 25
Commands Set List 27
System Commands Set 27
Halt and perform a cold 28
Port Commands Set 30
Trunk Commands Set 34
VLAN Commands Set 35
QOS Commands Set 41
IGMP Commands Set 42
SNMP Commands Set 44
Port Mirroring Commands Set 47
802.1x Commands Set 48
TFTP Commands Set 51
PoE Commands Set 51
SNTP Commands Set 55
X-ring Commands Set 56
Web-Based Management 58
System Login 59
System Information 60
IP Configuration 61
DHCP Configuration 62
DHCP Server Configuration 63
DHCP Client Entries 64
Port and IP Binding 65
TFTP - Update Firmware 66
TFTP - Restore Configuration 67
TFTP - Backup Configuration 68
SMTP Configuration interface 72
SNTP Configuration 75
SNTP Configuration interface 77
IP Security 78
IP Security interface 79
User Authentication 80
Port Statistics 81
Port Statistics interface 82
Port Control 83
Port Control interface 84
Port Trunk 85
 LACP disabled 87
 LACP enabled 89
Port Trunk—State Activity 93
State Activity of Switch 2 94
Port Mirroring 95
Rate Limiting 96
VLAN configuration 97
VLAN – Port Based interface 98
802.1Q VLAN 101
802.1Q Configuration 102
Group Configuration 104
Rapid Spanning Tree 106
RSTP—Port Configuration 109
SNMP Configuration 111
Trap Configuration 113
SNMPv3 Configuration 114
QoS Configuration 117
QoS Configuration interface 118
Port-Based Priority 119
COS Configuration 119
TOS Configuration 119
IGMP Configuration 120
IGMP Configuration interface 121
X-ring Interface 123
LLDP Interface 124
Multicast Filtering 125
System Configuration 126
802.1x Port Configuration 128
Misc Configuration 129
MAC Address Table 131
MAC Filtering 132
All MAC Addresses 133
All MAC Address interface 134
Power over Ethernet 135
Factory Default 137
Save Configuration 137
System Reboot 138
Problem Solving 139
Appendix 141
Communication Networks 143

Kommentare zu diesen Handbüchern

Keine Kommentare

Comnet CWGE2FE8MSPOE Technical Information Seite 86

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Comnet CWGE2FE8MSPOE